Here is my old DR650RS - Printable Version

Here is my old DR650RS - Printable Version

+- Dr Big (http://drbig.info)
+-- Forum: Technical (http://drbig.info/forumdisplay.php?fid=7)
+--- Forum: DR650/DR600 (http://drbig.info/forumdisplay.php?fid=18)
+--- Thread: Here is my old DR650RS (/showthread.php?tid=3082)

Pages: 1 2 3 4 5 6 7 8 9 10 11 12 13

Here is my old DR650RS - bigrob - 13-09-2019

[Image: 15683762543038948595192522622797.jpg]

The Yamaha is a little small for my height, but ok for local stuff. DR is much taller. Just got to refurb it.

Re: Here is my old DR650RS - H_Lime - 13-09-2019

Very nice.
I went to buy an rs once but couldnt kick start it Big Grin

In my defence i was only out of cast a couple wks. Is it difficult to start?

Re: Here is my old DR650RS - bigrob - 13-09-2019

Not so bad. I've had 3 XR650R'S, 1 x XR600R so not a problem.
But I do have legs like tree trunks. Banghead

Re: Here is my old DR650RS - Chris1215 - 14-09-2019

I had a Dr650 RSE when to the Elaffantruffen on it great bike

Re: Here is my old DR650RS - BigBob - 14-09-2019

When I got my DR600 many years ago and was struggling to kick it over, despite being 6ft 6 and 17 stone, and was given the following advice...
"Kick it like you are kicking a rapist off your mother" ..... never had a problem after that Wink

Re: Here is my old DR650RS - nug - 14-09-2019

My first DR600 nearly broke my leg on my first ride home. I stalled it in traffic and just instinctively booted it without consideration of where the piston was in its cycle. Couldn't walk for a week after that!
I soon got the knack and even started it wearing slippers just to prove the point Banghead

Not sure I would try it now.

Nice bikes bigrob Thumbup

Re: Here is my old DR650RS - bigrob - 15-09-2019

Thanks all.
I plan on fitting a Mikuni carburetor TM40-6-40mm flatslde pumper kit.
The header pipe is awful, no holes, but very rusty. The twin rear is holed up and the Y piece rusted through.
I have a large bore stainless header coming from Hessler in Germany, not sure which tail pipe to have yet.

All good stuff...........but I feel my wallet may become lighter.

I'll keep you posted. :clap:

Re: Here is my old DR650RS - bigrob - 17-09-2019

First purchase.....

[Image: 20190917_175937.jpg]

Header pipe from Hessler in Germany. But check out the weld inside the barrel end...

[Image: 20190917_180004.jpg]

Does the collective think I should smooth this down a bit ? Easy enough job to do !

I've seen how quickly some of you folk strip and rebuild your bikes on here, so it'll be under way soon.

Rob Large.

Re: Here is my old DR650RS - BigBob - 17-09-2019

I would be inclined to clean up the weld but I`m just fussy

Re: Here is my old DR650RS - bigrob - 17-09-2019

My thoughts exactly Bob. Just ordered a dremel type tool and some grinding attachments.